Have you ever taken the time to sit and think about how miserable summer would be without air conditioning services in Belton? This year, we have experienced numerous days with temperatures near 100 degrees, combined with humidity levels that make it feel close to 110 at times. These are dangerous conditions for people working outside, but also for people inside who do not have AC services in Belton.
The easiest way to ensure that your air conditioning in Belton continues to work efficiently is by doing a few simple routine tasks each year. These basic DIY chores are effective and maximize your AC unit to reach its full potential. Here are some step-by-step instructions on how to keep your HVAC services in Belton in tip-top shape.
#1 Shut Off the Power to the AC Unit
Whenever you are working near electricity, make sure you shut off any power coming to the unit. There should be an exterior power source on the outside of your home, and a breaker switch inside that should both be turned off.
#2 Get Rid of Excess Debris In and Around the Outside Unit
Once the power is off, remove the fan cage and the fasteners, then gently pull the cage from the unit. Once it has been removed, gather any leaves, twigs, dead grass, or other debris from the unit’s interior.
While the unit is turned off is a good time to clean the AC unit’s fins. Using a vacuum, remove as much thick dirt as possible, then hose down the fins gently with a garden hose. Do not use a pressure washer for this step; the high pressure could potentially damage the fins. There are commercial-grade fin cleaners available at local hardware stores if using a garden hose doesn’t do the trick.
Once your cleaning is done, reattach the fan cage.
#3 Make Sure the Unit is Level
One common problem for many homeowners’ air conditioning services in Belton is that their unit becomes unlevel over time. A unit that is unbalanced is more likely to have compressor failure than one that is completely balanced. If the condenser is not level, use rot-resistant shims to get it back on a level plane.
#4 Clean the Evaporator Coil
Another common problem that typically requires a service call to an HVAC repair company in Belton is a faulty evaporator coil. This important piece is located inside the interior HVAC unit and can be cleaned with a soft brush followed by a commercial-grade coil cleaner. This solution will foam up and drip into the drip pan, which should later be removed and cleaned.
#5 Replace the Blower Filter
The simplest DIY task for AC services in Belton is replacing the blower filter. This should be done at least twice a year, or more often if the filter gets dirty quickly. The filter should be replaced once before cooling season, so sometime before warm Spring temperatures set in. It should also be replaced before heating season, which is sometime in October for many people. This step can truly be done in less than a minute; just make sure you always have extra filters on hand.
#6 Turn Power Back On and Let the Unit Run
Once everything is back in place, turn on the unit and let it run for a bit. Since the unit was temporarily shut off during the cleaning process, it will need some time to get your home caught up to the right temperature. Check to see if things are still running smoothly and make sure everything is back in place like it was before you started.
Contact the Leaders in Heating and AC Repair in Belton
As a leading HVAC company in Belton, Comfort Systems Heating & Cooling hopes that these tips can help you improve your air conditioner’s performance this summer. If you need assistance with any other heating and cooling issues, give us a call today at 816-322-1013 or contact us online for more information.
